SparkFun GPS-RTK-SMA Breakout-ZED-F9P (Qwiic)-Concurrent reception of GPS GLONASS Galileo BeiDou High precision GPS 10mm 3 dimensional accuracy Receives L1C/A & L2C bands Voltage:5V or 3.3V Logic:3.3V
- Concurrent reception of GPS, GLONASS, Galileo and BeiDou. Receives both L1C/A and L2C bands
- Voltage: 5V or 3.3V but all logic is 3.3V. Current: 68mA – 130mA (varies with constellations and tracking state). Weight: 6.8g. Dimensions: 43.5mm x 43.2mm (1.71in x 1.7in). 2x Qwiic Connectors
- Time to First Fix: 25s (cold), 2s (hot)
- Max Navigation Rate: PVT (basic location over UBX binary protocol) – 25Hz. RTK – 20Hz. Raw – 25Hz
- Horizontal Position Accuracy: 2.5m without RTK. 0.010m with RTK. Max Altitude: 50km (31 miles). Max Velocity: 500m/s (1118mph)
HEX Technology Here+ RTK GNSS Kit
- Centimeter‑level GNSS positioning for the mass market
- Integrated Real Time Kinematics (RTK) for fast time‑to‑market
- Smallest, lightest, and energy‑efficient RTK module
- Complete and versatile solution due to base and rover variants
V30 V60 H32 V90 RTK GPS External Battery Power Cable 5-pin for Hi-Target PW-25 1.8m
- Connectors: 5 pin to alligator clips.
- Cable length: about 70″ (180 CM)
- Fit for Hi-Target V30 V60 H32 V90 RTK GPS GNSS
- to connect with car storage battery.
- Safe power supply
SparkFun GPS-RTK Dead Reckoning pHAT Compatible with Raspberry Pi-Concurrent Reception of GPS GLONASS Galileo BeiDou High Precision GPS – Receives L1C/A & L2C Bands Voltage:5V or 3.3V Logic:3.3V
- This product requires an antenna. Note that the ZED-F9R can only operate as a rover, so you will need to connect to a base station.
- 1x Qwiic Connector. Integrated U.FL connector for use with antenna of your choice. Concurrent reception of GPS, GLONASS, Galileo and BeiDou. 184-Channel GNSS Receiver. Receives both L1C/A and L2C bands
- Horizontal Position Accuracy: 0.20m with RTK. Max Navigation Rate: Up to 30Hz. Time to First Fix: Cold: 24s and Hot: 2s.
- Operational Limits: Max G: ≤4G, Max Altitude: 50km (31 miles), Max Velocity: 500m/s (1118mph). Velocity Accuracy: 0.5m/s. Heading Accuracy: 0.2 degrees. Built-In Accelerometer and Gyroscope. Time Pulse Accuracy: 30ns. Voltage: 5V or 3.3V but all logic is 3.3V. Current: ~85mA to ~130mA (varies with constellations and tracking state).
- Software Configurable: Geofencing, Odometer, Spoofing Detection, External Interrupt, Pin Control, Low Power Mode, Many others! Supports NMEA, UBX, and RTCM protocols over UART
Reach RS+ RTK GNSS Receiver with an App as a Controller
- Use cell phone or tablet as controller and data collection computer (iPhone or Android)
- Utilizes GPS, GLONASS, BeiDou, Galileo, QZSS and SBAS satellite signals
- Wi-Fi, Bluetooth, LoRa radio, and RS-232 to connect devices for corrections in or data out
- Built in LiFePO4 battery lasts up to 30-hours on a single charge.
- Ruggedized Package is IP67 Water and Dustproof, with wide operating temp range.
Bingfu RTK Survey GPS Antenna Extension Cable TNC Male to TNC Male RG58 Coax Jumper Cable 5m 16.5 feet for Trimble Topcon Leica Sokkia GNSS RTK Survey Vehicle Marine Boat GPS Navigation Receiver
- Connector Type: TNC Male to TNC Male; Cable Type: RG58A/U 50 Ohm Coax Cable; Length: 5m / 16.5 feet;
- Application: Broadcast Stereo Radio Transceiver Antenna Extension Cable, Patch Panel, Rack Mount;
- Application: Boat Ship Marine GPS Navigation Antenna Extension Cable, Trimble Topcon Leica Sokkia RTK Surveying Instruments RTK Survey GNSS GPS Antenna Extension Cable;
- Application: 4G LTE Cellular Wireless Home Phone Router Modem Antenna Extension Cable, Broadcast Stereo Radio Transceiver Antenna Extension Cable;
- Package List: 1 x Cable (As the Picture Shown)
SZRMCC Trimble GPS RTK GNSS Receiver 5700 5800 R6 R7 R8 R10 46125-20 Replacement Power Cable Alligator Clips to 0B 7 Pin
- Use the Alligator Clips to connect an 12V extended battery to power the Trimble GPS 5700, 5800, R6, R7, R8, SPS, 4700, 4800, RTK, such as a car battery….
- Trimble 46125-20 replacement. Will work with following Geodimeter Total Station systems: Trimble GPS 5700, 5800, R6, R7, R8, SPS, 4700, 4800, RTK. Trimble R10 GNSS Receiver
- Plug A: Alligator Clips Connector; Plug B: 0B 7 pin Male Connector + 15A fuse.
- Cable Length : 70.8Inches/1.8m (We can customize with other length, please contact us if you need).
- Each cable we produce has been rigorously tested and is compatible with machines from a variety of major brand suppliers,We are committed to all the products are qualified and high-quality.
As an Amazon Associate I earn from qualifying purchases.